Monday, May 31, 2010

[MW:5318] IQI set selection

Dear All

My job is Carbon steel and thickness is 20 mm. For radiography I have to select the IQI set as material group as “1” and wire type set as “A or B or C or D”. Can you please guide me how to select the set identification number based on thickness of job.

 

Thanks in advance

 

By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Re: [MW:35686] HDPE WPS

Refer ASME SEC IX  There is separate chapter for Plastic welding . Based on that you have to prepare  Sent from my iPhone On 21 Jun 2025, at...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...