Please check following extract from ASME Sec II part A – page 749.
I don’t think this clause renders the TC unacceptable.
With Regards,
V.Vaidyanathan
Welding Inspection Engineer │ Worley Parsons│Kuwait
( +965 238 61657 │ Fax. +965 2398 1695
www.worleyparsons.com
From:
Sent: Monday, April 19, 2010 7:37 AM
To:
Subject: Re: [MW:0] Acceptability of MTC.
Since this job according to ASME, as per ASME section II part A Copper content is not designated, So this MTC is not acceptable,Refer ASME sec-II -page 753.
V.Ravishanker
From: smruthi mohan <smruthi2007@rediffmail.com>
To:
Sent: Sun, 18 April, 2010 4:59:36 PM
Subject: [MW:4854] Acceptability of MTC.
Hi.
Anybody please advise me on the below,
we have an 12" End Cap (SA403 WP316L)for an ASME job. But in test certificate there is an additional element content (Cu (0,370))is present in the chemical Analysis. please advice me that we can accept this item or not.
Thanks in advance.
SMRUTHI MOHAN
ENGINEER - MATERIALS.
QICL,
| |
--
To post to this group, send email to
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
*** WORLEYPARSONS GROUP NOTICE *** "This email is confidential. If you are not the intended recipient, you must not disclose or use the information contained in it. If you have received this email in error, please notify us immediately by return email and delete the email and any attachments. Any personal views or opinions expressed by the writer may not necessarily reflect the views or opinions of any company in the WorleyParsons Group of Companies."
No comments:
Post a Comment