Re: [MW:12496] requirement for identification marking for plates A 283 GR C

thickness is 6mm.

 

Regards

On Wed, Sep 21, 2011 at 2:37 PM, FAKRUL KHAN <kfhasan62@gmail.com> wrote:

Hi, Asad,

 

Could you please provide the detail of the thickness for the plate as mentioned below.

 

 

On Tue, Sep 20, 2011 at 6:13 PM, asad azmi <azmiasadayub@gmail.com> wrote:

Dear All,

 

For shell plate material of SA283 Gr. C  material identification marking has been done on the plates by two method-

 

 1) stencling   2) steel die stamping

 

Plate number is not  availaible on the die stamping but it is availaible in stencling marking.

 

Whether the plate can be accepted with the above condition.( Plate number avaialible in Stencling marking only)

 

please provide your valuable suggestions.

 

Thanks & Regards

 

Asad Azmi

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.