if we refer to procedure for carry out DT (destructive test) for all welding WPS. the lab will carry out flush grind and polish. All the result refer on that,except for micro test.
so grind flush already in clude in ASME sextion IX . that shall look to procedure preparation test coupon.
On Fri, Jun 15, 2012 at 11:11 PM, BM <biswajit011210@gmail.com> wrote:
Dear Guru,Grinding the welds is permitted to the extent that at no place should the weld metal "fall below the surface of the adjoining base materials" -- see UW 35 (d). Proving that may be a difficult job, hence always leave a reinforcement unless constrained by design.RegardsBM
On Thursday, June 14, 2012 6:10:57 PM UTC+5:30, Guru H wrote:--Dear all,
Is flush grinding of welds acceptable in pressurevessels or pipes. If so please let me know the ASME code clause or some code reference.Thanks & Regards
Gurunath Hanamar
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
Comments