The other point did you purg the vessl fully during filling?
On Sep 20, 2013 9:41 AM, "Ali Al-Zawamri" <alzawamri@gmail.com> wrote:
-- Dear.
More clarification required.What was the temp.. at each step?
How you are sure no leak? What was the test done for leak ditection?
Can you breef the hydrotest arrangments?Regards,
On Sep 20, 2013 9:27 AM, "Mijiz Gruezy" <mijizgruezy@gmail.com> wrote:what if hydrotest made at 7pm and the given pressure is 5psi, after 11 hours of 6am, still reads the pressure 5psi, but at 9am, ie after 14 hours, Miter reading has dropped to 3.5Psi .. what is happening and its happening causes the condition?--
On Friday, September 20, 2013 11:22:37 AM UTC+8, Mijiz Gruezy wrote:Dear All,Why pressure drop occur even there was no leakage in hydrostatic test?
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.
No comments:
Post a Comment