[MW:921] Re: Welding Baffle Plate on EQ. TEE

Dear Mr. Shabbir,

Thanks for your reply

Appreciate if you can guide me where exactly I can find it in ASME Section VIII
Is it in Division 1 or 2, and under which section

Thank you,

Regards,

Sabir

On Mon, Jul 14, 2008 at 11:52 AM, shabbir ahmad <shabbir.ahmad7@gmail.com> wrote:

Dear Zameer

 

As per sec VIII u can welld over weld. dont worry u can weld ir , but do 100% MPI or DP

 

Regards

 

Shabbir

 

On 7/13/08, Zameer Mohammed <dreamthinkwork@gmail.com> wrote:

Dear Friends,

We have to weld a Baffle plate of 10mm Thick inside an EQ. TEE (24'', 36'' & 42''). The thickness of the TEE is 9.53 mm and all the EQ. TEES are welded construction with 100% RT. The Baffle plate is welded in such a way that, it will block the one run side of the EQ. TEE. Now the welding of the Baffle plate, will it creates and problem as it intersect with EQ. TEE weld at some point. Can we have two welding at a same point? The Baffle plate is fillet welded. The working pressure is 1 bar.

Kindly advice me,

Thank you,

Regards,

 

Sabir