You are allowed but you have to revise your Wps without a new PQR.
For the realization you should start with some buttering to reduce the gap
Best regards
Dr Georgios Dilintas
Authorized Nuclear Inspector
Authorized Inspector Supervisor
HBS Regional Technical Manager
From: lukman hakim [lukman_hakim1981@yahoo.com]
Sent: 15/11/2011 10:16 ZE8
To: materials-welding@googlegroups.com
Subject: [MW:12981] Joint preparation-root gap
| Dear All, I have problem in joint preparation. According to design drawing & WPS the root gap for welding 48mm carbon steel plate by SMAW process is 3 mm, but actual we have gap more than 10 mm. This welding is for pressure vessel (ASME VIII Div.2). Can we weld this joint with gap more than 10 mm? as per ASME IX for SMAW process root gap is not essential variable. Thanks Best regard, Lukman |
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
No comments:
Post a Comment