Dear Mr.Kumar,
The Material storage or poor from your attachement no end protection
due to reason inside having more rust probably.
remove rust throughly by blasting and measure and confirm the
thickness as to be meet the client approved design thickness
/Costruction codes - including th e tolerances subject to be
accepted.
Regards,
Alikan.
On 10/19/12, Kumar kerala <sk7920541@gmail.com> wrote:
> Dear forum members,
>
> Kindly be sharing my concerns about "deeply rusted materials " (different
> sizes, thickness about 9.53mm). the appearance of the
> materials are poor. the thickness is measured by UT gauge and found in
> required limits. but the mill coating of materials are damaged
> in most of the cases, which is the main issue...are these are really to be
> rejected in client point of view ( elbows- WPB-234, A 106 pipes
> etc...)...these materials were stored in poor conditions with supplier...
> expecting opinions fromm all corners...
> NB: photos attached.
> regards,
> Kumar.
>
> --
> To post to this group, send email to materials-welding@googlegroups.com
> To unsubscribe from this group, send email to
> materials-welding+unsubscribe@googlegroups.com
> For more options, visit this group's bolg at
> http://materials-welding.blogspot.com/
> http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
>
> The views expressed/exchnaged in this group are members personel views and
> meant for educational purposes only, Users must take their own decisions
> w.r.t. applicable code/standard/contract documents.
>
>
>
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
Subscribe to:
Post Comments (Atom)
-
Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
-
Definition of buttering from ASME Section IX, QW/QB-492 Definitions: Buttering: the addition of material, by welding, on one or bot...
-
Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...
No comments:
Post a Comment