Re: [MW:13990] PWHT OF P91 BY INDUCTION HEATING

Dear sandeep,

 

Ya this is not acceptable. Because the temperature difference range is 732 Deg, C to 774 Deg C for P15E material as per B31.3 (2010 Edition).

 

I have understood from your mail, there is access to put the thermocouple means you can put more thermo wool to with stand the heat & start to monitor the temperature recorder, still it is coming down try to put more wool & dummy on both sides.

Regards,

E.Subramanian/Balaji.R

On Sun, Mar 25, 2012 at 12:04 AM, Harish Kannepalli <harishkannepalli@gmail.com> wrote:

Dear sandeep,

                 Please try putting coil inside the pipe also. As per code more than 60°C difference is not allowed.

2012/3/24 sandeep monody <smv.monody@gmail.com>

Dear experts,

 

In my site we conducted a demonstration of PWHT on SA335 P91 material (OD-450mm X 70mm Thk) as our clients requirement and details as given below.

 

Heating/cooilng rate;-60 deg C,Holding temparature:-760deg C and holding time:-180minutes,Heating band width:-210mm and insulation band width 630mm,Heating method :-Induction heating

 

During pwht we observed a temparature difference on outside and inside of pipe more than 80 deg C.

 

Now problem is that client is not accepting this method and asking for uniform temparature in outside and inside of pipe.

 

How can i control temparature at both sides?

Is it possible a uniform temp on both side with induction heating?

 

Please give ur valueble advice in this matter.

 

 

Sandeep.

QC Engr

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--

regards,

Harish.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--

Regards,

E.Subramanian

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.