Re: [MW:13923] Painting before pressure test on pipings - B 31.3

No. there should not be paint application on joints of piping  which are to be Hydro test or Pneumatic test .


Regards,
RK Vichare





----- Original Message -----

From: madhan chozhan

To: materials-welding@googlegroups.com

Sent: Sun, 18 Mar 2012 09:12:16 +0530 (IST)

Subject: [MW:13914] Painting before pressure test on pipings - B 31.3

Gents,

Good day.

I need to know whether leak test (hydro or pneumatic) can be done on piping after painting is done on the welds of pipe line?

ASME B 31.3 says "345.3 Preparation for Leak Test

345.3.1 Joints Exposed. All joints, welds (including

structural attachmentwelds to pressure-containing components),

and bonds shall be left uninsulated and

exposed for examination during leak testing, except that

joints previously tested in accordance with this Code

may be insulated or covered. All joints may be primed

and painted prior to leak testing unless a sensitive leak

test (para. 345.8) is required."

"345.8 Sensitive Leak Test

The test shall be in accordance with the Gas and Bubble

Test method specified in the BPV Code, Section V,

Article 10, or by another method demonstrated to have

equal sensitivity. Sensitivity of the test shall be not less

than 10−3 atm·ml/sec under test conditions.

(a) The test pressure shall be at least the lesser of

105 kPa (15 psi) gage or 25% of the design pressure.

(b) The pressure shall be gradually increased until a

gage pressure the lesser of one-half the test pressure or

170 kPa (25 psi) is attained, at which time a preliminary

check shall be made. Then the pressure shall be gradually

increased in steps until the test pressure is reached,

the pressure being held long enough at each step to

equalize piping strains"

here text in green says it shall be left uncovered expect that joints previously tested in accordance with this code(which test to be done for exception and where it is mentioned on code?) but the text in red says it may be primed and painted which looks controversial, kindly advice me what to follow.

--


To post to this group, send email to materials-welding@googlegroups.com


To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com


For more options, visit this group's bolg at http://materials-welding.blogspot.com/


The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.