Friday, May 29, 2020

[MW:30936] Re: maximum and minimum size of Dish end end SPIN hole plate.

I  HAD A doubt. In one of my job, we made patch of 100 mm. RT was done and the results were 100% satisfactory. Can you please suggest whether the patch of 100 mm is allowed or not. Is that mentioned in any code or so. About spin hole, it is already  mentioned in code under UW 34. The spin hole is allowed till 60 mm but we made a patch of 100 mm and did RT whose results were satisfactory.

Regards,

Arun 

On Thursday, September 6, 2012 at 9:16:10 AM UTC+5:30, hemant wrote:

Dear Sir,

What is the minimum  & Maximum size of spin hole plate as per code reference. Pls reply me.

 

HEMANT SUTHAR

QA/QC

CEPL-SILVASSA

9712973092I 

 

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/46181c29-1951-43bb-ac51-81a9be49bf9b%40googlegroups.com.

No comments:

Re: [MW:35241] Overlay welding defects

Dear Sir, The below is another type of defect,Mostly these two type of defects we faced. Regards, R.Gowtham. On Wed, Sep 11, 2024 at 1:42 PM...