Dear Mr.M Farhang
If you wanted to know whether the material is normalized or not go for
microstructure.if ASTM no obtained is greater than 5 then the material
is said to be normalized.as above ASTM no 5.fine grain structure is
observed.
Regards
Sarfaraz Tambe
QA/QC Engineer
On 1/23/13, M2M <hyperm2m@gmail.com> wrote:
>
>
> Dear All
>
>
>
> I need to know how can understand that ASTM A516 Gr.70 is normalized or
> not?
>
>
>
> Somebody told me:
>
> "according to clause 5.3 of ASTM A516 standard (attached), when we apply
> charpy impact test on a material and it pass the impact test successfully,
> we can say the material is surly normalized but if the material can't pass
> the impact test, we shall apply metallographic test to understanding if the
> material is normalized.
>
>
>
> And somebody said me:
>
> "we have just 1 way to know that is the material normalized or not. And its
> metallographic test."
>
>
>
> M. Farhang
>
>
>
>
>
>
>
>
>
> --
> To post to this group, send email to materials-welding@googlegroups.com
> To unsubscribe from this group, send email to
> materials-welding+unsubscribe@googlegroups.com
> For more options, visit this group's bolg at
> http://materials-welding.blogspot.com/
> http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
>
> The views expressed/exchnaged in this group are members personel views and
> meant for educational purposes only, Users must take their own decisions
> w.r.t. applicable code/standard/contract documents.
>
>
>
--
Regards
TAMBE Sarfaraz.
mob. 9960860167
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
Subscribe to:
Post Comments (Atom)
Re: [MW:34832] Inquiry about Single Bevel with Back Grinding
Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...
-
Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
-
Definition of buttering from ASME Section IX, QW/QB-492 Definitions: Buttering: the addition of material, by welding, on one or bot...
-
Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...
No comments:
Post a Comment