Hi Greetings,
Pre Qualified:
1) Clause 23 is not applicable in your case as both are butt.
2) Clause 24 applies here for your case, yes it is an essential variable, as it says change in groove weld details as shown in figures and does not says within the figures, hence change in as shown in the following figures (any) will be an essential variables.
By Qualification:
More over as you have mentioned PQR and WPS, i doubt this should be contemplated as per table 4.5, clause 31, 32, 33 and 34, in which you will get knocked and which will be essential varibale again as same above.
Note: Discussion open to personel interpretaions.
Thanks.
Regards,
Mohamed Muneeb Mahaboob
CSWIP 3.2-89247/2
IRCA-9001:2015 LA
ASNT-NDT-L2-RTFI-RT-UT-MT-PT.
SAP#:70021650 APs:JAPID, QCS & QCI.
''If you know any art by any means then SCULPT IT - no matter how cheap or useless it is - JUST SCULPT IT, you will never know when experts will be on demand''
Dear All,Please I have small query refer below Query.--1) Joint Details: In PQR Joint details given "SINGLE 'V' GROOVE.
But in WPS "SQUARE BUTT JOINT" Is it Acceptable..
as per table 3.7 AWS D1.1 Clause no-23 &24 Variable
WPS Joint Details as below.
Please any one give urgent reply for my query.
Regards
Kiran
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.
Comments