this is 18" dia pipe. If internal clamp is not possible, (like tie in joints) we can use external clamp . We developed different PQR-WPS for both internal and External clamp welding. Internal with downhill progression and external clamp wps with uphill progression . But in a circumstance we used in Internal clamp and Welded with the parameters as of External Clamp. Only the clamp type in different
-- Is it acceptable ?
With Regards
Riaz
On Sunday, 18 November 2018 07:53:17 UTC+5:30, Bilal Wahla wrote:
On Sunday, 18 November 2018 07:53:17 UTC+5:30, Bilal Wahla wrote:
external clamp and internal clamps depends on dia of pipe. So how you guys can change clamps?.--It is in violation with conjuction to the governed approved WPS, if the paramaters of the both WPSs are not similar for shuffling.Thanks.
Regards,Mohamed Muneeb MahaboobCSWIP 3.2-89247/2 & AWS-CWI (2007)ASNT-NDT-L2-RTFI-RT-UT-MT-PT.SAP#:70021650 APs:JAPID, QCS & QCI.Say (O Muhammad SAW to mankind). "If the sea were ink for (writing) the Words of my Lord, surely, the sea would be exhausted before the Words of my Lord would be finished, even if we brought (another sea) like it for its aid."18-109
Dear All,--External clamp and internal clamp WPS and PQR procedures are qualified with downhill process and uphill process respectively. But one joint has welded with internal clamp following all other variables as of external clamp WPSIs this acceptable ? If yes , how can we justify ?Pls help very urgentRay
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-weld...@googlegroups.com .
Visit this group at https://groups.google.com/group/materials-welding .
For more options, visit https://groups.google.com/d/optout .
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-weld...@googlegroups.com .
Visit this group at https://groups.google.com/group/materials-welding .
For more options, visit https://groups.google.com/d/optout .
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.
No comments:
Post a Comment