Hello,
Section II Part A specifies electrodes, too.
Best Regards,
Shashank C Vagal (Quality Adviser), (+91) 8082395502, 8779046302,
NEO METAL-ANALYST & NDT SERVICES
· A-25, Geet Siddhi, Boradevadi, Moshi-Haveli, PCMC, Pune 412105
· 301, PRATHAMESH, M G Rd – Mahant Rd, Vile Parle East, Mumbai 400 057 INDIA
www.neometalanalystndt.com / enquiry@neometalanalystndt.com / nach_sam@yahoo.com
On Wednesday, 12 September, 2018, 7:17:30 PM IST, adeel <adeelscet@gmail.com> wrote:
Dear Experts,
-- Please answer this question
For example designer selected a material SA517 Gr B for work.
I went to to table Q/QB 422 for P no. & G no. ... I found P no. is 11B and G no. 4.
Then i went to Section ii Part A where i found SA 517 Material is alloy steel and its SFA no. is 5.5.
After that what shuould I do ?
experts (Who has thorough of ASME Section IX) please tell me step by step how to select exact filler material. from section ii part C.
I shall be very thankful to All of you for this act of kindness.
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.
No comments:
Post a Comment