IQIs are not calibrated.
For penetrameter calibration refer to T-262
Στις Σάβ, 10 Οκτ 2020 στις 6:39 π.μ., ο/η Manish Kumar <mkmkr431@gmail.com> έγραψε:
Dear Sir,--Which clause number as per ASME section V, calibration of IQI/ penetrameter is required ?.Pl advise--RegardsManish KumarInspection(Mechanical) EngineerPDIL-HURL Barauni site
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAHfQ4k4-WLe8zRvsgZN%2B1vbCb%3D%3DSMc2E1kOQ7sFZGT65dEnXiQ%40mail.gmail.com.
Dr. Georgios Dilintas,
Dipl. Ing. In Aeronautic and Space Engineering
Ph.D in Mechanics of Solids - Computational Mechanics
A.I.S, A.N.I, IRCA Lead Auditor
Welding, Stress Analysis, Corrosion, QA/QC, Failure Analysis, Risk Analysis
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAPOi40CFBwQ5FwEYk%3DfrnKQ7H_Z4-CTJAGc7dCP5oUX1RGEQGQ%40mail.gmail.com.
No comments:
Post a Comment