Re: [MW:31544] Calibration of IQI

Please refer article 22 in section 5. Long back I seen. 

Sent from Yahoo Mail on Android

On Sat, 10 Oct 2020 at 9:58, 'james gerald' via Materials & Welding

<materials-welding@googlegroups.com> wrote:

Please see snap shot of ASME Sec.V  Article 2 below.

Thanks & Regards

J.Gerald Jayakumar

On Saturday, 10 October, 2020, 10:39:37 am GMT+7, Manish Kumar <mkmkr431@gmail.com> wrote:

Dear Sir,

Which clause number as per ASME section V, calibration of IQI/ penetrameter is required ?.

Pl advise

--

Regards

Manish Kumar

Inspection(Mechanical) Engineer

PDIL-HURL Barauni site

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAHfQ4k4-WLe8zRvsgZN%2B1vbCb%3D%3DSMc2E1kOQ7sFZGT65dEnXiQ%40mail.gmail.com.

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/733090594.26457.1602311986866%40mail.yahoo.com.

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/604135289.106236.1602321979370%40mail.yahoo.com.