ASME Sec.V defines only about Densitometer Calibration as explained in the previous mail.
IQI/Penetrameter Clibration is not defined in the Code as the IQI comes in a packed condition and there will be no variation observed during usage and incase if it is damaged then it can be replaced.
nly thing cansideredo using IQI is the selection of IQI based on the material used and of similar
Thanks & Regards
J.Gerald Jayakumar
0091-6382552037
On Saturday, 10 October, 2020, 10:39:37 am GMT+7, Manish Kumar <mkmkr431@gmail.com> wrote:
Dear Sir,
-- Which clause number as per ASME section V, calibration of IQI/ penetrameter is required ?.
--
Pl advise
Regards
Manish Kumar
Inspection(Mechanical) Engineer
PDIL-HURL Barauni site
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAHfQ4k4-WLe8zRvsgZN%2B1vbCb%3D%3DSMc2E1kOQ7sFZGT65dEnXiQ%40mail.gmail.com.
No comments:
Post a Comment