Please see snap shot of ASME Sec.V Article 2 below.
Thanks & Regards
J.Gerald Jayakumar
On Saturday, 10 October, 2020, 10:39:37 am GMT+7, Manish Kumar <mkmkr431@gmail.com> wrote:
Dear Sir,
-- Which clause number as per ASME section V, calibration of IQI/ penetrameter is required ?.
--
Pl advise
Regards
Manish Kumar
Inspection(Mechanical) Engineer
PDIL-HURL Barauni site
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAHfQ4k4-WLe8zRvsgZN%2B1vbCb%3D%3DSMc2E1kOQ7sFZGT65dEnXiQ%40mail.gmail.com.
No comments:
Post a Comment