Monday, June 23, 2014

[MW:21240] Product Marking as per SA 106 of ASME Sec. IIA, Ed. 2013.

Dear Experts,

Refering to Cl. No. 25 of SA 106 of ASME Sec. IIA, Ed. 2013, Pipe Length shall be marked in feet and tenths of a foot [meter to two decimal places] but no one reputed pipe manufacturer mark the length of pipe on pipes. Does it really require? If require, then I think it is an NC and shall have to close before use.

Further, what shall be the reason for not allowing/ accepting the latest edition/ addenda (2011a) of ASTM/ ASME in Table II-200-1? For eg., if we refer 
By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Re: [MW:35506] WPS for Furnace PWHT

Dear Sir, I am not clear about the question. Is the question is "The welding is done without following a WPS having  PWHT and actually ...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...