Dear all, pl. give solutions for the following. PSP
--- On Sun, 9/5/10, great world solutions <solutions.great@gmail.com> wrote:
From: great world solutions <solutions.great@gmail.com>
Subject: Fwd: techinical support
To: "prashant pansare" <prashantpan_99@yahoo.co.in>
Date: Sunday, 9 May, 2010, 12:01 PM
Dear Prasanth, Below some technical advise require, hope if you can help me out puting this to your circle or material weld please mail me once you get datas. For the following case: Pressure rating 15000 Psi Design temp. 175 deg cen H2S is 100 ppm by vol. CO2 is 10% by vol. Corrosion rate 10mm / yr Chloride 80,000 by vol. Present material considered is A790 UNS 31803 for flow arm piping ( DSS) Please advice if the above mat. is compatible or suggest better suitable options regards, sabari
|
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at
http://materials-welding.blogspot.com/ The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
No comments:
Post a Comment