Dear Ali
The thickness of the clad should have been mentioned in the equipment data sheet and more over it should say the intent of the clad. If the thickness of the clad is only for corrosion then u need not consider clad thickness in the design calculation. If this data is missing then u need to ask the client and I wonder how it was estimated if this data was not available in the design data. The sour requirement does not come from code and usually it is dictated by the project documents so u need to find an answer to ur question in the spec for clad thickness or get in touch with ur client.
Usually what I have seen is that the clad thickness for a clad plate is 3 mm after the manufacturing process is completed and the weld overlay part depends on the wps at what height u can achieve the undiluted chemistry. The height is calculated from the approximate weld interface (refer fig QW 462.5 a), so if the project doc does not specify then follow this.
I hope ur query is answered.
Regards
NS
On Mon, Jul 23, 2018 at 6:24 PM Ali Asghari <asgharialigl@gmail.com> wrote:
Dear All.--Does anybody know about how a designer calculate the thickness of clad material especially for sour service and how much is conservative?because in our project documents have not said clearly that thickness of clad have to be measured from base material or from layer that dilution is negligible and this question remained does designer account or consider dilution or not?Regards.
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.
No comments:
Post a Comment