Dear Jerry,
You should consider Definition of joint and weld is different.
We can make lap joint with fillet weld
There is some standards just for definition
Best Regards,
Alireza Samimi Mottaghi
International welding engineer-Senior Welding inspector-Lecturer of IWE
+61-411509219
Australia-Newcastle
-----Original Message-----
From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of JERRY TUAN
Sent: Monday, May 25, 2015 11:28 PM
To: materials-welding@googlegroups.com
Subject: [MW:23032] Lap joint
Dear experts and seniors. If groove weld can cover for fillet weld, AWS D1.1 , can it cover for lap joint? Cause I read some where else in AWS D 1.1 that lap joint weld can be consider as fillet weld. Thanks all
--
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To post to this group, send email to materials-welding@googlegroups.com.
Visit this group at http://groups.google.com/group/materials-welding.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/75138ccf-9864-45ce-8198-2977e5a9da56%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
--
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To post to this group, send email to materials-welding@googlegroups.com.
Visit this group at http://groups.google.com/group/materials-welding.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/12a401d09773%242d6129c0%2488237d40%24%40yahoo.com.
For more options, visit https://groups.google.com/d/optout.
Subscribe to:
Post Comments (Atom)
Re: [MW:35241] Overlay welding defects
Dear Sir, The below is another type of defect,Mostly these two type of defects we faced. Regards, R.Gowtham. On Wed, Sep 11, 2024 at 1:42 PM...
-
Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
-
Definition of buttering from ASME Section IX, QW/QB-492 Definitions: Buttering: the addition of material, by welding, on one or bot...
-
Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...
No comments:
Post a Comment