Thursday, September 8, 2011

[MW:12380] Welding Consumables and procedure for STACKER MILL ROLLS-FURNACE GUIDE ROLL-25CrMo5V

Dear Members,
Kindly suggest the weldind procedure for the following application:
 
STACKER MILL ROLLS-FURNACE GUIDE ROLL-25CrMo5V
400MM Diameter
Depth of drill (Puncture problem) 140mm
Hardness required-250-270BHN
TEMP. 800 -1000 Degree C
 
Regards
 
Naveen
 
By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

[MW:34916] Applicability of Impact requirement as per ASME B31.3

Dear All, Design code – ASME B31.3, Welding Code- ASME BPVC SEC IX Material  to be used used during Fabrication - SA 333Gr6 (P No.1 G...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...