Friday, September 10, 2010

Re: [MW:6948] Hole in splice plate

Dear Pushpraj ,
 
Hole is provided for escape of entrapped gases

G.S.Arora
B4-103 LaHabitat
Opp Marutinandan Villa
Near Aayna Shopping Complex
Off SG Road Thaltej
AHMEDABAD-380054
Ph: 91-9725262404


--- On Fri, 10/9/10, Pushpraj Anand <pushprajanand34@gmail.com> wrote:

From: Pushpraj Anand <pushprajanand34@gmail.com>
Subject: [MW:6944] Hole in splice plate
To: materials-welding@googlegroups.com
Date: Friday, 10 September, 2010, 3:50 PM


Dear Sir,
 
Why the hole is required in splice plate during joing of two beams by slice plate ?
 
 

 
--
Regards,
Pushpraj Anand

Contact No: +919234655254

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...