Sunday, September 12, 2010

[MW:6966] Buttering of weld joints

Could any one says, wats the allowable/acceptable thickness for
buttering?
according to AWS D1.1? Where to refer in AWS D1.1

THANKS

On Jun 12, 11:27 am, "Subrata Das" <s...@pkgroup.org> wrote:
> Dear Sir
>
> Can anyone describe me what is "BUTTERING"  stands for in welding joint. If
> it is done before depositing the weld metal on job, is it necessary to
> remove the same by back chipping.  

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...