Tuesday, September 10, 2024

Re: [MW:35234] Re: 10% & 12.5 % ACCEPTANCE CRITERIA BASE ON CODE AND STANDARDS

Hello Sir Dhatchana,

Thank you & I appreciate your support, however, the 12.5 % range tolerances for welding metal are not indicated to ASME SEC 1 B-8.2.

Thank you again.

On Saturday, September 7, 2024 at 12:48:29 AM UTC+8 Dhatchana moorthy.S wrote:
Hello Sir,

ASME SEC I Page 356 B-8.2

Regards,
Dhatchanamoorthy.S


On Fri, Sep 6, 2024 at 2:38 PM Rizaldy kien Caringal <kiencar...@gmail.com> wrote:
Hello Sir  Mohd

 Which item in ASME II Part C is discussed the tolerances?

On Fri, Sep 6, 2024 at 1:51 PM Mohd Siraj <mohd...@gmail.com> wrote:
ASME II-C

On Friday, September 6, 2024 at 8:24:33 AM UTC+3 Rizaldy kien Caringal wrote:
Dear Inspector Experts,

In some PMI reports, I found a comment written on the bottom side. The measured value of material alloying elements shall be within 10 percent of the specified level, and 12.5 percent for the weld base metal. From where tolerance has been taken. is it mentioned in any codes and standards & what standard did we refer to?


Thank you for your support & Information.

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-weld...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/29a8c56d-f9a3-4d25-9df2-d226e9f685a5n%40googlegroups.com.

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-weld...@googlegroups.com.

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/4c74cda2-8d8d-4b13-b409-c6a568adbef0n%40googlegroups.com.

No comments:

Re: [MW:35289] Welding consumable for S355J2WP material

S355 J2 WP  is a weathering structural steel  It has better atmospheric corrosion resistance. Use E 8018 - W1/W2  Electrodes This is regular...