[MW:35256] Moderator's spam report for materials-welding@googlegroups.com

This message is being sent to you because you are a moderator of the group materials-welding.

The following suspicious messages were sent to your group, but are being held in your moderation queue because they are classified as likely spam messages.

If you take no action, all the messages below will be discarded automatically as spam.

However, if you see any messages that are not spam below, you may approve them individually by going to:

https://groups.google.com/group/materials-welding/pendmsg

Please do not mark this notification as spam; this is a service for group moderators. If you do not wish to receive these notifications in the future, you may change your preferences by going to:

https://groups.google.com/group/materials-welding/manage_post


------- 1 of 2 -------
Subject: Re: [MW:35250] in socket weld gap should be 1.5mm to 3mm and radiography should be 10% is it mention in b31.3 or not?
From: Vishwas Keskar <vvkeskar123@gmail.com>
Date: Sep 12 09:42PM +0530

Gap 1.5 mm is addressed .

RT is not addressed

Sent from my iPhone

On 12 Sep 2024, at 8:10 PM, Mohd Yasoob Azeem <yasoobazeem786@gmail.com> wrote:

Dear friend,

Greeting!

in socket weld gap should be 1.5mm to 3mm and radiography

Approve: https://groups.google.com/group/materials-welding/pendmsg?view=full&pending_id=7157372831607500715

------- 2 of 2 -------
Subject: Re: [MW:35250] in socket weld gap should be 1.5mm to 3mm and radiography should be 10% is it mention in b31.3 or not?
From: Deepanshu <khatrideepanshu@gmail.com>
Date: Sep 13 10:26AM +0800

Dear Sir,

According to B31.3 -2020.

Clause 311.2.2 - Socket Welds (b) (2) - Weld dimensions shall not be less
than shown in figures 328.5.2B and 328.5.2C.

Clause 341.4.3 (b) - Socket welds and branch connection welds that are not

Approve: https://groups.google.com/group/materials-welding/pendmsg?view=full&pending_id=4130998086890239607


For more information about this message, please visit:
https://support.google.com/groups/answer/2466386