Re: [MW:32219] GMAW change gas from 100 %CO to Ar+5%O2

Thanks Dear Ramin,

Because of lots of fume due to CO2

On Sun, Apr 11, 2021 at 10:52 AM Ramin Kondori <raminkondori@gmail.com> wrote:

Why did you change the shielding gas...?

Ramin  Kondori

Sr. QA/QC & Welding Engineer

-----------------------------------------------------------

PG-Dip. in Welding Engineering (IWE  AT  0070)

BSc. in Civil Engineering (IUT)

BGAS Painting Inspector

ASNT Level I&II

                        

On Fri, Apr 9, 2021 at 5:03 PM EmaD FaRaHanI <emad.farahani@gmail.com> wrote:

Dear all,

I faced a problem with penetration in fillet welds when decide to change the gas type, as mentioned.

Most welders are doing well with this change, but some make loser penetration.

Details: mild steel, 2F welding position, wire feed speed 450ipm (optimized), 10˚ push angle, 

What could be the reason?  

Thanks,

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CABtwbJHGLowgBKiJe0796zrL7d00pp%3DwikLdgxRHq1dWt%3DQHtw%40mail.gmail.com.

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAEagfUj5CxTCB43XpoeUAXHqZVYLYaYRew344oy82vHR8anY2Q%40mail.gmail.com.

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CABtwbJEJLgD_FfA8wuqBwNyWwsh2xRv5QhxXL7gQunoJ0Mwa9g%40mail.gmail.com.