Re: [MW:20206] ULTRA SONIC TESTING

No sketches with the bevel orientation have to be developed
Best regards
Dr Georgios Dilintas
Authorized Nuclear Inspector
Authorized Inspector Supervisor
HBS Regional Technical Manager

---

  From: prem_nautiyal26 [prem_nautiyal26@yahoo.com]
  Sent: 03/01/2014 10:09 AM ZE5B
  To: materials-welding@googlegroups.com
  Subject: Re: [MW:20202] ULTRA SONIC TESTING

Hi

The thumb rule for angle probe selection is (90degrees - bevel angle).

Regards  

Prem Nautiyal

9769316004

Sent from Samsung Mobile

mark89 <mayurkotiwar77@gmail.com> wrote:

Dear sir , 

 

As per my knowledge the thumb rule to select the probe angle is ( 90- t ) where t = thk of material . i would like to know how to select  probe angle in UT if material thk is more than 100 mm .

Thanks .

Regards , 

Mayur kotiwar 

mayurkotiwar77@gmail.com

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
 
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.
This message contains confidential information. To know more, please click on the following link: http://disclaimer.bureauveritas.com