Wednesday, July 18, 2012

Re: [MW:14888] Maximum Spin Hole Diameter for Dish End

not acceptable


On 7/14/12, sevak hiren <hirensevak80@gmail.com> wrote:
> At the time of forming the spin hole dia was less than 60 mm around 30 mm,
> but while forming the crack was observed at spin hole, so the hole was
> extended to 70 mm & the patch was welded. RT is also done for patch weld.
>
> But as per Section VIII Div I, is it acceptable ?
>
> On Fri, Jul 13, 2012 at 5:01 PM, Swapnil Vanjara
> <swapnil.vanjara@gmail.com>wrote:
>
>> first of all tell me haw ur dia bcm more than 60
>>
>>
>> On 7/13/12, Swapnil Vanjara <swapnil.vanjara@gmail.com> wrote:
>> > first of all tell me haw ur dia bcm more than 60
>> >
>> >
>> > On 7/13/12, sevak hiren <hirensevak80@gmail.com> wrote:
>> >> Dear Experts,
>> >>
>> >> As per ASME section VIII Div I , UW-34, max. allowable patch diameter
>> for
>> >> a
>> >> spin hole of dishend is 60 mm.
>> >>
>> >> If, the dish end spin hole patch diameter is found to be of more than
>> >> 60
>> >> mm
>> >> then the dish end should be rejected, please correct me if I am wrong.
>> >>
>> >>
>> >> Thanks in advance.................
>> >>
>> >> --
>> >> To post to this group, send email to
>> >> materials-welding@googlegroups.com
>> >> To unsubscribe from this group, send email to
>> >> materials-welding+unsubscribe@googlegroups.com
>> >> For more options, visit this group's bolg at
>> >> http://materials-welding.blogspot.com/
>> >> The views expressed/exchnaged in this group are members personel views
>> >> and
>> >> meant for educational purposes only, Users must take their own
>> >> decisions
>> >> w.r.t. applicable code/standard/contract documents.
>> >>
>> >
>>
>> --
>> To post to this group, send email to materials-welding@googlegroups.com
>> To unsubscribe from this group, send email to
>> materials-welding+unsubscribe@googlegroups.com
>> For more options, visit this group's bolg at
>> http://materials-welding.blogspot.com/
>> The views expressed/exchnaged in this group are members personel views
>> and
>> meant for educational purposes only, Users must take their own decisions
>> w.r.t. applicable code/standard/contract documents.
>>
>
> --
> To post to this group, send email to materials-welding@googlegroups.com
> To unsubscribe from this group, send email to
> materials-welding+unsubscribe@googlegroups.com
> For more options, visit this group's bolg at
> http://materials-welding.blogspot.com/
> The views expressed/exchnaged in this group are members personel views and
> meant for educational purposes only, Users must take their own decisions
> w.r.t. applicable code/standard/contract documents.
>

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

[MW:35346] Cast-iron welding

Any advice for cast iron welding Sent from Yahoo Mail for iPhone