Monday, January 31, 2011

Re: [MW:9600] Flattening Test for SA 106

 
Dear Bathula,
 
Thanks for the Quick Response.
I would still look forward where the defination of "Under" and "Above" is clearly defined in ASME/ASTM Standards.
 
Regards
VPV
____________________________________________________________________
On Mon, Jan 31, 2011 at 2:05 PM, Bathula Raghuram (Mumbai - PIPING) <R.Bathula@ticb.com> wrote:

Excludes 2"

Refer para  11.1 "For pipe NPS 2 and under a sufficient length of pipe shall stand being bent cold through 90°………….."

 

 

From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of Vino Varghese
Sent: Monday, January 31, 2011 4:24 PM
To: materials-welding@googlegroups.com
Subject: [MW:9597] Flattening Test for SA 106

 

Dear Experts,

 

Refer to Section 12.0(Flattening Test) of SA 106, ASME Sec II Part A.

This Section states that - " For Pipe over NPS 2 a section of pipe not less than........"

 

Question: Does the above Interpretation includes 2" or excludes 2" for the Flattening Test?

Do provide the reference of ASME/ASTM which supports the Interpretation.

 

The MTC recieved does not reflect the Flattening Test.( Material - 2", Sch 80, SA 106 Gr.B for Sour Service)

 

Hope to see as usual co-operation from everyone in Material Group.

 

Thanks & Regards

Vino P Varghese

Doha-Qatar


--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...