Sunday, October 24, 2010

[MW:7762] Separation of joint

Dear All,
 
During fit-up of two spools of SS304, It was observed that logitudinal seams of pipe are coming face to face, means there is no separation between long seams of large dia pipe. Is there any criteria stated in asme B31.3  or Aramco standard in this regard.
 
Regards,
 
Ahmed H.
 

 

By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

[MW:34920] Tubesheet Hole step

Hello Team, I have one question any tolerance given for tubesheet Hole step. Please do needful. Regards, AP  -- https://materials-...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...