Re: [MW:5708] UT check - Round bar

If your client spec not mentioned, then you can use ASME V, SA 388, 'V' Notch as a reference sensitivity.

 

Regards,

S.Senthilkumar

---

From: v dhinesh <dhineshsir@gmail.com>
To: materials-welding@googlegroups.com
Sent: Tue, 22 June, 2010 5:57:57 PM
Subject: Re: [MW:5706] UT check - Round bar

Hi,

    If it is specified or required by project specification then only it is required and this will be done at manufacturer. You have to request when you order for the materal.

Regards,

DHINESH

On Tue, Jun 22, 2010 at 9:15 AM, Dharmesh Mistry <Dharmesh.Mistry@heurtey.in> wrote:

Hi,

 

Foundation bolt M 42

Is it required to perform Ultrasonic Inspection on round bar before threading?

If yes, which standard will applicable for performance & acceptance?

 

Best Regards,

DHARMESH MISTRY

Cell +91 98207 35814

Dharmesh.Mistry@heurtey.in

 

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.