Thursday, September 23, 2010

[MW:7168] Wearing of plasite paint

Dear All

 

We have received feed back from customer that HP & LP Shell of the compressor, have hade complete disintegration of plasite coating and excessive rust formation in the shell . An excessive plasite wearing has been noticed on the shell

 

We have used plasite 7156 and conformed as per the specification called during painting in house

 

Could experts give feed back for such failure and cause for the same?. We shall have to take corrective action

 

Thanks

 

Regards

 

Prashanth Hegde



Please don't print this e-mail unless you really need to.
*******************************************************************
This e-mail is confidential. It may also be legally privileged. If you are not the addressee you may not copy, forward, disclose or use any part of it. If you have received this message in error, please delete it and all copies from your system and notify the sender immediately by return e-mail. Internet communications cannot be guaranteed to be timely, secure, error or virus-free. The sender does not accept liability for any errors or omissions.
*******************************************************************
"SAVE PAPER - THINK BEFORE YOU PRINT!"

No comments:

[MW:34820] RE: 34813] Clarification in Rate of heating and cooling.

Hello,   Please see the response below.   Regards.   P. Goswami, P. Eng, IWE.   From: materials-welding@googlegroups.com <materials-weld...