Re: [MW:27413] Is recommended for conducting PAUT in lower tickness tube

This Code Case is applicable only for ASME Code Section I items

2018-02-26 12:34 GMT+02:00 'Ganesan' via Materials & Welding <materials-welding@googlegroups.com>:

Dear Experts,

Could you please advise, whether PAUT is recommended lower thickness (Dia 2inch X 4 to 5.5 mm thick).

As i knew that below 6mm not recommended for the PAUT according to ASME Case 2816.  

 

Thanks & Regards, 

K.GANESAN 

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.

--

Dr. Georgios Dilintas,

Dipl. Ing. In Aeronautic and Space Engineering

Ph.D in Mechanics of Solids - Computational Mechanics

A.I.S, A.N.I, IRCA Lead Auditor

Welding, Stress Analysis, Corrosion, QA/QC, Failure Analysis, Risk Analysis

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.