Friday, October 11, 2013

[MW:18915] Ball Valve Machined,.

Dear Experts,

I have three ball valves 1" 1500 # , were machined one side for welding (were for threaded).
My question is, How check the new dimensions of this sockets weld??
Table 4, ASME 16.34 ??
Is acceptable this practice?


Thanks in advance for your advice. 

Rogelio A.
By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

[MW:34919] Welder qualification certificate

Dear All     anyone can share a format for welder certificate and card format        Thanks & Best Regards Saleem manhappulath Mob:+9665...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...