Wednesday, May 27, 2009

[MW:2242] Re: 2238] pump damage

Nilesh,
Thanks a lot for this splendid artcle. Very useful for all in the field. Appreciate.
Regards,
Shashank Vagal


--- On Wed, 27/5/09, Darji Nilesh (Mumbai - Machinery) <N.Darji@ticb.com> wrote:

From: Darji Nilesh (Mumbai - Machinery) <N.Darji@ticb..com>
Subject: [MW:2239] RE: 2238] pump damage
To: materials-welding@googlegroups.com
Date: Wednesday, 27 May, 2009, 10:01 AM

Sadique,

Refer attached article. For Nanhai we used Gaussmeter to check residual
magnetic field in Pumps as Client observed that during Pump
suction/discharge pipe welding, Flanges were bolted to pump flanges.

With regards,

Nilesh Darji
Engg. & Designs Tecnimont ICB
-----Original Message-----
From: materials-welding@googlegroups.com
[mailto:materials-welding@googlegroups.com] On Behalf Of Sadique Sheikh
Sent: Tuesday, May 26, 2009 7:48 PM
To: materials-welding@googlegroups.com
Subject: [MW:2238] pump damage


Hello all of you.
I have one query and may hope the answer from expert member from field.
On our site,the welder did the welding of pipe while the pipe flange
was bolted to pump.so that time small spark occured between the flange
and the noise enclosure i.e cover of pump as some paint removed from
edge of enclosure which was in direct contact with flange that time.
So my question is can it affect the bearing of pump as pump base is
already grounded.
Regards
Sadique





Filtered by Hosted Filtering


Bring your gang together. Do your thing. Find your favourite Yahoo! Group. --~--~---------~--~----~------------~-------~--~----~
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding-unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
-~----------~----~----~----~------~----~------~--~---

By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Re: [MW:35501] TEST COUPON ASME SEC IX

Yes, You can machine the Plate.  Prepare the Welding Running Sheet and mention 14 mm Plate machined to 8 mm Plate.  then the groove weld qua...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...