The electrode has to so through the same PWHT as specified in your procedure qualification.Regardless of what is said in Sec II part C. (because you are heat treating the weld metal also
during your procedure qualification). U need to prove that your electrode will perform in this condition.
Regards
On Wed, Nov 3, 2010 at 7:19 AM, limesh M <limesh78@gmail.com> wrote:
--Dear All,Design Code- ASME B31.3Welding Code - ASME SEC IXProcess - GTAW+SMAWI have a WPS which is qualified with PWHT and impact test.Now I have to review some consumable MTC.I need advise on the following queries.1.Is it mandatory that the consumable MTC shall show the mechanical test values with PWHT for acceptance ?2.Can I accept consumable MTC which is matching with corresponding SFA and material properties with out PWHT?Regards,Limesh
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
No comments:
Post a Comment