Hi Narayanan,
Please refer the discussions and the answers provided the following link. The spots may appear due to few issues:
- Type of lubricants used during wire drawing of the GTAW filler wires. Typically oil based lubricants if used could generate such residues, while soap type lubricants may not.
- Surface finish of the SDSS. If the products are acid cleaned & pickled after manufacturing the chances of such welding dross would be less.
Irrespective of those facts, the discussions in this following link are worthwhile to look at.
Thanks.
Pradip Goswami.P.Eng, IWE.
Independent Welding & Metallurgical Engineering Specialist
Linkedin: https://www.linkedin.com/in/pradip-goswami-2999855/
Email:pgoswami@rogers.com,pradip.goswami@gmail.com
Cell/Whasapp:1-905-9793232
Black spots on DSS Weld Joints. (google.com)
From: materials-welding@googlegroups.com <materials-welding@googlegroups.com> On Behalf Of Narayanan Kumar
Sent: October 11, 2022 9:31 AM
To: materials-welding@googlegroups.com
Subject: [MW:33587] Black dots on sdss welding
Dear Team,
Can you please explain about the black dots appears on SDSS GTAW Weld bead( ER 2594 ) with document backup for the causes
Regards,
M.Kumar
--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CADTvyj%2B9Ti77s60HeABOGGgrcOeok0BG2nwCqMQQ8zrDqdyGyw%40mail.gmail.com.
No comments:
Post a Comment