As per the ASME Sec II Part C page no 11 in the general notes indicates weld layer shall be no more than 2.5 times of the diameter of the core wire.
M.R.Pramodh
Sr.QC-Insallah Gas Compression
From: BHARAT GOLE <bharatgole@hotmail.com>
To: Material Welding <materials-welding@googlegroups.com>
Sent: Mon, December 6, 2010 7:00:34 AM
Subject: RE: [MW:8522] Weld Weave
More weaving will also cause more dilution !
Regards
Bharat B. Gole
Date: Mon, 6 Dec 2010 11:05:27 +0530
Subject: Re: [MW:8520] Weld Weave
From: jaydeep.p.joshi@gmail.com
To: materials-welding@googlegroups.com
EN standards recommend to limit the weave width to 3 times electrode diameter
ASME Code doesn't suggest the limit of weaving but as a good engineering practice, it is restricted to 3 x Electrode Dia in case of SMAW and 12-13mm Max. in case of FCAW / GMAW.
Effect of weaving:
1. Reduction in number of passes to be deposited
2. increasing the heat input
3. Higher weaving also results in reduction of shielding gas at the edges if the parameters are not properly set
4. It affect the side wall fusion, need to ensure the proper dwell time at the ends
5. Weaving speed need to be control otherwise causes the arc deflication
6. Higher weaving causes the reduction in impact properties
Jaydeep Joshi | TDW India Limited
Plot No 16 | Phase –III | Alindra – Savli G.I.D.C | Taluka : Savli | Vadodara – 391 775
Board : +91-2667- 619900 | Fax : +91- 2667- 619501| Extension : 7845
E-Mail : jaydeep.joshi@tdwilliamson.com | www.tdwilliamson.com
Cell: +91 9978959626
P Before printing, Think about ENVIRONMENTAL responsibility
On Sun, Dec 5, 2010 at 8:30 PM, Adi <adinraos@gmail.com> wrote:
Dear all
if the weld weave length increased What will happen to weld and what
is the corrective action to be taken for weld
please advise
is any code reference, please tell me
Adi
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
Comments