Thursday, June 18, 2020

Re: [MW:31015] PWHT for fillet welds ASME B 31.3

Carbon steel


On Thu, Jun 18, 2020 at 15:00, pradip kumar Sil <pradipsil@gmail.com> wrote:
Which Material

On Fri, Jun 12, 2020 at 3:50 PM Ilkin Hasanov <ilkinhasanov.91@gmail.com> wrote:
Hi Gents 
Could you please advise are there any requirements for PWHT of fillet welds asper ASME B 31.3 ?


Regards, 
Ilkin Hasanov

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CADrxeDYy1_AmnHNMtBWM48rpC827G52WPSFvyt7SUwg%3D3%2BOy6g%40mail.gmail.com.

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CAB%3DAs8k2T6EU23JQ7GLVvYW_qCoejEngRy4G_%3DMbWxpHwdJJCw%40mail.gmail.com.

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CADrxeDafjkM4ydCDOJhhg8t43ghUvsRkMLFOTF1FKRCo3GOSxA%40mail.gmail.com.

No comments:

Re: [MW:35241] Overlay welding defects

Dear Sir, The below is another type of defect,Mostly these two type of defects we faced. Regards, R.Gowtham. On Wed, Sep 11, 2024 at 1:42 PM...