Why the weld patches are not acceptable ?
Generally on fine machined surface weld repair spots are visible.
But if the repair by welding is approved by code then acceptance criteria shall be according to the applicable NDT METHODS.
Regards,
Nilesh Pathare.
On 02-Sep-2017 8:20 AM, "Gopi Nath" <gosri2813@gmail.com> wrote:
Dear sir,
I had find weld spatches after welding in machined valve body . This is not accepted. Material ASTM A487 Gr 4C. Need your solution
--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com .
Visit this group at https://groups.google.com/group/materials-welding .
For more options, visit https://groups.google.com/d/optout .
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
For more options, visit https://groups.google.com/d/optout.
Comments