Dear All,
As per ASME sec I alignment tolerance are as per below table.
On shop floor QC people clears the butt joint set up with reference to above table.
Question is mismatch is primary cause for lack of fusion. Why these tolerance means?
Any code does not permits lack of fusion.
Any one can clear above doubt.
-- As per ASME sec I alignment tolerance are as per below table.
On shop floor QC people clears the butt joint set up with reference to above table.
Question is mismatch is primary cause for lack of fusion. Why these tolerance means?
Any code does not permits lack of fusion.
Any one can clear above doubt.
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
No comments:
Post a Comment