Dear Prem Sir,
Good afternoon
Yes ,you can use this technique , but before using this technique ,you have to revise your MT procedure and add yoke technique in the procedure and send for client approval.
Thanks & Regards.
Santosh Gaikwad
Surat,India.
Santosh Gaikwad
Surat,India.
On Sat, Dec 14, 2013 at 8:31 PM, prem nautiyal <prem_nautiyal26@yahoo.com> wrote:
--Hi friendsWe have approved an MPT procedure for fasteners -- SA 193M Gr B7, full threaded studs, M42 X 2700 mm long which are going to be used for an heat exchanger.Approved MPT procedure mentions coil shot and head shot technique for the studs.However vendor does not have facility for head shot / coil shot technique and has Yoke technique facility.Vendor has requested for Yoke technique for these studs instead of head shot/coil shot.Can we accept Yoke technique for these size of studs ?RegardsPrem Nautiyal9769316004
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.
No comments:
Post a Comment