Hi,
Is it possible to increase the joint quality factor of SAW pipes?
As per B31.3, joint quality factor for SAW pipes is 0.95, but the code has not mentioned anything about increasing this joint quality factor to 1 by any additional testing.
Could you please provide me any reference from the code or its interpretation which permits to increase the joint quality factor by carrying out 100% RT.
Regards
Syed Moin
______________________________________________________
CONFIDENTIALITY NOTICE: This electronic mail transmission may contain information that is confidential, privileged, proprietary, or otherwise legally exempt from disclosure and is intended only for the use of the recipient named above. We do not waive confidentiality in the event this mail was transmitted wrongly. If you have received this communication in error, and are not the intended recipient, you are hereby notified that you are prohibited from reading, printing, copying, or disseminating this message, any part of it, or any of the attachments it may carry. If you have received this message in error, please destroy all electronic and paper copies and notify the sender immediately of the inadvertent transmission. We would like to advise you that we would not waive any of our privilege for taking action against you in the event the confidentiality of this message has been compromised. Thank you for your cooperation
________________
This email has been scanned by the MessageLabs Email Security System.
For more information please visit http://www.messagelabs.com/email
______________________________________________________________________
No comments:
Post a Comment