Tuesday, June 26, 2018

[MW:27984] thickness qualified

Dear all,

Good morning

 

Could you please advise on this matter?

 

 

Sub-contractor welder qualified plate T: 16mm as per Sec IX. (maximum can be weld as per Table: QW-452.1(B)

 

shall he can be welded in a plate T: 10mm if possible, where is it mentioned in the Sec IX. Please….

 



Regards 

 

Raja kumarasamy
Welding & Piping inspector
Salalah LPG Project
Oman Gas Company (OGC)

By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

[MW:35536] RANGE ASME SEC IX

Dear All we have qualified WPS for ( ASME SEC IX) 1. BASE plate 8 mm ( 8TO 16 mm RANGE WITH IMPACT )  2 . BASE plate 25 mm ( 16TO 50mm RANGE...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...