I agree not to bend the film cassette but what about cutting the cassette to fit inside and placing IQI across the weld? Alsom you can “blow” the weld onto the film but need to realize this will give you a distortion of the weld.
Jean Staton
Corporate RSO/Quality, Safety, Environmental Manager
METCO - Materials Evaluation & Technology Corporation
27 Sawyer St, Beaumont, TX 77702
Phone: (409) 835-2600
Fax: (409) 835-1199
Cell: (409) 553-9460
Email: jean.staton@metco-ndt.com
Website: www.metco-ndt.com
From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of george.dilintas@gr.bureauveritas.com
Sent: Tuesday, January 10, 2012 6:46 AM
To: materials-welding
Subject: Re: [MW:13449] NDE FOR BUTT WELD
I would not suggest to bend the film cassette. UT using angle and straight probes is more appropriate. However I am surprised that there is no a tapered transition as required by most of the codes in case of unequal thickness
Best regards
Dr Georgios Dilintas
Authorized Nuclear Inspector
Authorized Inspector Supervisor
HBS Regional Technical Manager
From: "Desai Jignesh (Mumbai - Piping)" [J.J.Desai@ticb.com]
Sent: 10/01/2012 15:27 ZE5B
To: "materials-welding@googlegroups.com" <materials-welding@googlegroups.com>
Subject: [MW:13441] NDE FOR BUTT WELD
Can somebody write me about the possibility of either radiography OR Ultrasonic testing of attached butt weld?
We have tried to carry out radiography with and without non metallic support as in the attached snaps but image is not clear.
Regds/Jignesh
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
DISCLAIMER: The information contained in this e-mail may be confidential and is intended solely for the use of the named addressee. Access, copying or re-use of the e-mail or any information contained therein by any other person is not authorized. If you are not the intended recipient please notify us immediately by returning the e-mail to the originator.
No comments:
Post a Comment