Thursday, February 18, 2016

[MW:24322] acceptance criteria for undercut

Hi experts in welding inspection


Is attached highlighted undercut acceptable assuming the depth in pipe edge is max 0.5 mm


pipe is welded to slip on flange from front side so it is internal weld from flange face side

construction code is ASME B31.3

Can you refer to code sections?


regards


Martin.

By -

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Re: [MW:35686] HDPE WPS

Refer ASME SEC IX  There is separate chapter for Plastic welding . Based on that you have to prepare  Sent from my iPhone On 21 Jun 2025, at...

  • Materails FAQs
    Q: What are equivalents for standard Q 235 B (and Q 235 A) for U-channels? ...
  • RE: [MW:5585] Buttering of weld joints
    Definition of buttering from ASME Section IX, QW/QB-492 Definitions:   Buttering:  the addition of material, by welding, on one or bot...
  • WELD AND WELDING SYMBOLS
    Section I. PRINT READING 3-1. GENERAL a. Drawings . Drawing or sketching is a universal language used to convey all necessary information to...