Can you add information about thickness or schedule.
On Fri 31 May, 2019, 13:28 G.K.PILLAI, <pillai762000@gmail.com> wrote:
Hi Gents,--I have one doubt that we qualified two wps for branch connection as per bsen 15614-1 with branch angle 35degree , main pipe die 800mm branch pipe dia 400mm root gap 2- 5 mm without backing strip and another one wps is same as above only different that rootgap 8-20 mm (widegap) with backstrip.test results was acceptable. in this both wps can i have to use the single joint .it means the same degree of the branch joint half of the joint where ever rootgap 2-5 mm with out backstrip and another half of the joint wherever root gap 8-20 mm with back strip based on above wps.please confirm.Thanks&Regards,
G.K.PILLAI.
MOBILE
+919500755882 (INDIA)
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CACmDAmVOTLA_NMGdjVx2C6sZ46ysefu%2BKpSLO53rRBujd7BaRQ%40mail.gmail.com.
For more options, visit https://groups.google.com/d/optout.
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
Visit this group at https://groups.google.com/group/materials-welding.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CA%2BQ29OhSS-m2nRzFshfxOs9eSfoK7sFn7%2B_0_Zx%3D_%3DUQhrcY9w%40mail.gmail.com.
For more options, visit https://groups.google.com/d/optout.
No comments:
Post a Comment